![]() Install your First Flush Plus tee in place by applying solvent weld glue to the sockets and pipe. Ensure all cut edges are clean and smooth. The outlet of your diverter must sit at least 150mm (6”) from the ground when fully assembled, so select your installation point and measure and cut accordingly. Measure your existing downpipe and cut to create space for the First Flush Plus tee. This will determine which socket on the First Flush Plus tee will attach to your diversion chamber. Select the orientation of the First Flush Plus tee appropriate for your chosen installation point. (Refer to Figures 1a, 1b and 1c for suggested installation orientations). The outlet must be accessible for maintenance and inspection. The First Flush Plus tee can be installed in the horizontal or vertical orientation to suit your installation. 3 feet of 3” pipe holds 1.2 gallons of water. 1 metre of 80mm pipe holds approximately 4.6 litres of water. ![]() As a rough guide, 1 metre of 90mm pipe holds approximately 5.9 litres of water. If you aren’t using the Max Chamber adaptor, you will need to determine the length of 90mm (80mm or 3”) pipe required for your first flush diversion chamber. 3 feet of 4” pipe holds 2 gallons of water. As a general guide, 1 metre of 100mm pipe holds 8.8 litres of water. If you’re using the Max Chamber adaptor to create your first flush diversion chamber, you will need to determine the length of 100mm pipe you require.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |